DRAW Reference Manual
Labelling
:
Creating and Manipulating Labels
: Leader Line Gaps
Leader Line Gaps
A leader line may have up to 10 gaps in it. These are most easily defined using the cursor, with either the start and end points or a mid-point and a length being specified. (In the latter case a default gap length will be assumed if a value is not specified.) Examples of the relevant commands are:
GAP @
Insert gap by specifying start and finish points with cursor
GAP AT @
Insert gap of default length centred on cursor position
GAP AT @ L 5
Insert 5mm gap centred on cursor position
GAP OVER @
Insert gap by specifying start and finish points with cursor, and delete all other gaps in line
GAP DELETE @
Delete gap specified by cursor
GAP DEL ALL
Delete all gaps on current Sheet
GAP TIDY
Deletes all unused gaps from Label
The default gap length may be set by using the SETDEFAULT GAP command, for example:
SETDEF GAP 5
Set default gap length to be 5mm
Gaps in Label leader lines can be sketched and erased in the same way as Dimension projection line gaps. Refer to
Detail Attributes of Linear Dimensions
for further information.
1974 to current year.
AVEVA Solutions Limited and its subsidiaries. All rights reserved.
