Catalogues and Specifications
Reference Manual
Piping Components
:
Special Components
: Dynamic PPOINTS
Dynamic PPOINTS
In order to calculate dimensions and tube lengths, a set of dynamic ppoints are provided to suit the number of cuts being used. For example on a single cut bend we would require a ppoint on the inside centre and outside as shown below plus extra cuts if insulation is added.
The points are arranged with the centreline ppoint as number 10, Inside point as 11 outside point as 12 and then points 13 and 14 as the inside and outside insulation points respectively.
Because of the dynamic nature of the ppoints, the ppoint numbers are directly related to individual cuts, multiplied by ten, so cut 1 will have five ppoints numbered from 10 to 14 and cut 2 will have five ppoints from 20 to 24. additional ppoints will be available for each additional cut defined by the cut number times ten with the same configuration as described earlier.
1974 to current year.
AVEVA Solutions Limited and its subsidiaries. All rights reserved.
