DRAW Reference Manual
Annotating Structural Elements in DRAW
:
P-line Attributes
: P-line Design Element
P-line Design Element
The name of the Design element to which the p-line applies is stored in the DDNM attribute of the annotation element. When a p-line is in use, the p-point attributes (NPPT or PPDI) are normally unset (value -1). The exception to this is where p-line is used for angle. This case is described further in the section on p-line angle.
If p-line data for an annotation element is replaced by a direct reference to a Design element or p-point, then the p-line attributes (PKEY and PKDI) are set back to the default values.
1974 to current year.
AVEVA Solutions Limited and its subsidiaries. All rights reserved.
