ISODRAFT
User Guide
Bolting
: Bolting Report
Bolting Report
The user can use ISODRAFT to produce a Bolt Report, either to the screen or to a file. This takes the form of an ASCII file with a page length defined by the user. The user can specify whether they want the bolting information to replace an existing file, or be added to an existing Bolt Report File (which is the default).
To produce the report use the BOLTREPORT command. This command is similar to the DETAIL command in that the pipes to be detailed are scanned for bolting information. The user can repeat the report whenever they want, interspersing the BOLTREPORT commands with DETAIL and CHECK commands as necessary. The user will experience the same system checks when producing a bolt report as for detailing, but here only diagnostic information relevant to bolting will be produced. Therefore, the user does not have to make sure that all piping geometry is correct before producing a bolt report. Note, however, that it is important to have the piping’s connectivity correct before producing a bolt report to make sure that all pipes are scanned properly.
The user can include positional information in the report. This will give the user the centreline position of either associated flange in the coordinate system (as currently defined by the AXES command). The format of the positional information will be determined by the UNITS command.
For further information see the chapter
Command Reference Section
in the
ISODRAFT Reference Manual.
1974 to current year.
AVEVA Solutions Limited and its subsidiaries. All rights reserved.
