Rectangular Silencer r

HVAC

Components : Inline Plant Equipment : Rectangular Silencer r

The task of creating an HVAC Component is initiated from the HVAC Window.

Select Inline Plant Equipment in the Categories drop-down list and then RECTANGULAR, Silencer in the Available Type drop-down list to display the Silencer window:

You are required to input the following dimensions:

•

•

•

•

•

To visualise how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for Rectangular Silencer.

Note:

The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalogue.

Click Transpose Width/Depth to exchange Duct Width AA dimension with the Duct Width AB dimension.

Specify a type of joint to use for the Arrive Joint and Leave Joint. Refer to Create/Modify HVAC Component for a detailed description.

After selecting the type of joint to use for the Arrive Joint and Leave Joint you must enter the Width Direction.

In the Width Direction specify the axis that should be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).

In the Position list, select Connect or Unchanged:

•

Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

•

Click Unchanged (default when Modify is selected) - positions the component at the co-ordinates 0.00.

Note:

Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.

Click Defaults to reset all the fields back to when the Silencer window was opened.

Click Fit to orientate the Silencer to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.

Click OK to create the Silencer component and close the Silencer Window. You will be returned to the HVAC Window.

Click Cancel to discard all the field changes and close the Silencer window.