HVAC

Components : Transformations : Square to Flat Oval
The task of creating an HVAC Component is initiated from the HVAC Window.
Select Transformations in the Categories drop-down list and then Square to Flat Oval in the Available Type drop-down list to display the Square to Flat Oval window:
To visualise how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for Square to Flatoval.
Note:
The fields will be pre-populated with default dimension. These dimension are governed by the details defined in the HVAC Catalogue. The Rectangle and Oval Extension default is auto but can be changed by you to a required dimension.
Click Transpose Width/Depth to exchange Rectangle Width AA dimension with Rectangle Depth AB dimension or exchange Oval Width LA dimension with Oval Depth LB dimension.
Specify a type of joint to use for the Rectangle Joint and Oval Joint. Refer to Create a Component for a detailed description.
After selecting the type of joint to use for the Rectangle Joint and Oval Joint you must enter the A Offset Direction.
In A Offset Direction enter the direction for the A Offset relative to the Point of Origin. Valid directions are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).Using the Flip Oval/Rect drop-down list, you can choose whether to flip the direction of arrive and leave of the of the piece of HVAC, 180° relative to the point of origin.
In the Position list, select Connect or Unchanged:
Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.
Click Unchanged (default when Modify is selected) - positions the piece of HVAC at the co-ordinates 0.00.
Note:
Unchanged is usually used, when Modify is selected, it does not connect the piece of HVAC but positions it at 0.00, in effect in a floating position.
Click Defaults to reset all the fields back to when the Square to Flat Oval window was opened.
Click Fit to orientate the Square to Flat Oval to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.
Click OK to create the Square to Flat Oval component and close the Square to Flat Oval Window. You will be returned to the HVAC Window.
Click Cancel to discard all field changes and close the Square to Flat Oval window.

1974 to current year. AVEVA Solutions Limited and its subsidiaries. All rights reserved.
AVEVA Logo