Gasket

HVAC

The task of creating an HVAC Component is initiated from the HVAC Window.

Select Flat Oval in the Categories drop-down list and then Gasket in the Available Type drop-down list to display the FlatOval Gasket window:

You are required to input the following dimensions:

•

•

•

•

To visualise how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for Gasket.

Note:

The fields will be pre-populated with default dimension. These dimension are governed by the details defined in the HVAC Catalogue.

Click Transpose Width/Depth to exchange Duct Width AA dimension with Duct Depth AB dimension.

In Width Direction enter the specify the Axis that should be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).In the Position list, select Connect or Unchanged:

•

Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

•

Click Unchanged (default when Modify is selected) - positions the piece of HVAC at the co-ordinates 0.00.

Note:

Unchanged is usually used, when Modify is selected, it does not connect the piece of HVAC but positions it at 0.00, in effect in a floating position.

Click Defaults to reset all the fields back to when the Gasket window was opened.

Click Fit to orientate the Gasket to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.

Click OK to create the Gasket component and close the Gasket Window. You will be returned to the HVAC Window.

Click Cancel to discard all field changes and close the Gasket window.