7 Segment Bend

HVAC

Components : Circular : 7 Segment Bend

The task of creating an HVAC Component is initiated from the HVAC Window.

Select Circular in the Categories drop-down list and then 7 Segment Bend in the Available Type drop-down list to display the 7 Segment Bend window:

You are required to input the following dimensions:

•

•

•

•

•

•

•

To visualise how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for 5 Segment Bend.

Note:

The fields will be pre-populated with default dimensions These dimensions are governed by the details defined in the HVAC Catalogue. The Arrive and Leave Extension is auto but can be changed by you to a required dimension.

Specify a type of joint to use for the Arrive Joint and Leave Joint. Refer to Create/Modify HVAC Component for a detailed description.

After selecting the type of joint for the Arrive Joint and Leave Joint you must enter the Leave Direction.

In Leave Direction specify the axes that should be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).

In the Position list, select Connect or Unchanged:

•

Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

•

Click Unchanged (default when Modify is selected) - positions the component at the co-ordinates 0.00.

Note:

Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.

Click Defaults to reset all the fields back to when the 7 Segment Bend window was opened.

Click Fit to orientate the 7 Segment Bend component to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.

Click OK to create the 7 Segment Bend component and close the 5 Segment Bend Window. You will be returned to the HVAC Window.

Click Cancel to discard all field changes and close the 7 Segment Bend window.