Test Holes

HVAC

The task of creating an HVAC Component is initiated from the HVAC Window.

From the HVAC Window select Rectangular in the Categories drop-down list and then Test Point in the Available Type drop-down list to display the Test Holes window:

You are required to input the following dimensions:

•

•

•

•

•

•

•

•

Note:

The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalogue. The No of Test Holes default is as defined in the HVAC Catalogue but can be changed by you.

To visualise how the dimensions equate to the actual piece of HVAC click Picture to display a detailed drawing for Test Holes.

Click Transpose Width/Depth to exchange MAIN Width LA dimension with MAIN Depth LB dimension.

In Holes Direction specify the axis to be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).The Clash Vol fields will be pre-populated with the obstruction volumes associated with the access panel and the ducting, but can be changed by you.

In the Position list, select Connect or Unchanged:

•

Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

•

Click Unchanged (default when Modify is selected) - positions the component at the co-ordinates 0.00.

Note:

Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.

Click Defaults to reset all the fields back to when the Test Holes window was opened.

Click Fit To Next to orientate the Test Holes to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.

Click OK to create the Test Holes component and close the Test Holes Window. You will be returned to the HVAC Window.

Click Cancel to discard all field changes and close the Test Holes window.