HVAC
Components : Rectangular : Taper
Select Rectangular in the Categories drop-down list and then Taper in the Available Type drop-down list to display the Taper window:
|
•
|
|
•
|
|
•
|
To visualise how the dimensions equate to the actual piece of HVAC click Picture to display a detailed drawing for Taper.
|
Note:
|
The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalogue. The Arrive and Leave Extension default is auto but can be changed by you to a required dimension.
|
Click Transpose Width/Depth to exchange Duct Width AA dimension with Duct Depth AB dimension or to exchange Duct Width LA dimension with Duct Depth LB dimension.
Specify a type of joint to use for the Arrive Joint and Leave Joint. Refer to Create/Modify HVAC Component for a detailed description.
After selecting the type of joint to use for the Arrive Joint and Leave Joint you must enter the A Offset Direction.
In the A Offset Direction enter the direction for the A Offset or B Offset relative to the Point of Origin Valid directions are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).In the Position list, select Connect or Unchanged:
|
•
|
|
•
|
Click Unchanged (default when modify is selected) - positions the component at the co-ordinates 0.00.
|
|
Note:
|
Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.
|
Click Fit to orientate the Taper to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.
Click OK to create the Taper component and close the Taper Window. You will be returned to the HVAC Window.
