Component Clearance Vertically

Model Reference Manual

This command places the current Component on the constrained centreline at a specified vertical clearance above or below a fixed object. If the Arrive or Leave point of the referenced object is used, then the Tube cross-section emerging at this point is considered rather than the full item geometry.


Examples:
CLEARANCE ONTO /BEAM	The current Component will be placed on the constrained centreline at zero clearance above the specified object (see Figure 8:27.: Component clearance above/below a fixed object).
CLEARANCE 50 UNDER /BEAM	The current Component will be placed on the constrained centreline at 50 vertical clearance below the specified object (see Figure 8:27.: Component clearance above/below a fixed object).
CLEAR 50 ONTO IDP @	The current Component will be placed on the constrained centreline at a clearance of 50 vertically above the picked p-point. If this p-point is an Arrive or Leave, then the Tube cross-section will be taken into account (see Figure 8:27.: Component clearance above/below a fixed object).

Command Syntax:

>-- CLEArance --+-- <uval> --.
                |            |
                ‘------------+-- ONTop --.
                             |           |
                             ‘-- UNDer --+--  <gid> ---.
                                         |             |
                                         |-- <marke> --|
                                         |             |
                                         ‘-- <bpos> ---+-->

Querying:

>-- Query <marke> --+-- POSition --.
                    |              |
                    |-- BOP -------|
                    |              |
                    ‘-- TOP -------+-- WRT --.
                                   |         |
                                   ‘-- IN ---+-- <gid> -->

Figure 8:27.

Component clearance above/below a fixed object