Catalogues and Specifications Reference Manual
Checking Catalogue Database Consistency using PARAGON : What the Checking Facility Does
What the Checking Facility Does
The following tests may be carried out:
At SPEC level:
•
Check that no question in the specification is repeated.
•
Check that one question in the specification is TYPE.
•
From the TYPE reference, check that the GTYPE of the COMP has the same setting.
•
From the TYPE reference, check that the SKEY setting of SDTE is correct.
•
From the TYPE reference, check that the point set has the correct geometry, as required by ISODRAFT.
At SPCO level:
•
Check that all of the following reference attributes are set: CATREF, DETAIL, MATX, CMPR, BLTREF. (The BLTREF need be set only if the connection type begins with F or L.)
At COMP or equivalent level:
•
Check that there is a valid PTREF and GMREF.
•
At a PTSE, check that P-points are set and that there are no duplicate numbers.
•
At a GMSE, check that there are primitives set and that they are not degenerate. Check also that no invalid P-point numbers or parameters are used. Note that this test uses catalogue parameters, so that if a primitive is constructed only from design and insulation parameters, spurious warnings will be generated.
•
Check that each P-point connection type exists in the COCO tables. P-points used for construction purposes can have connections of 0.0, NUL or NULL. The connection type will not be checked for validity for a specific type of component.
•
Check that a P-point bore is valid for a recognised set of nominal bores. P-points used for construction purposes, and a P-point with connection type CLOS, can have a zero bore.
1974 to current year. AVEVA Solutions Limited and its subsidiaries. All rights reserved.
AVEVA Logo